#Mbed programming nucleo f401re how to
#Mbed programming nucleo f401re install

Go to the Nucleo Firmware page and scroll down to the bottom of the page and select the link First install the ST-Link driver.

To check and upgrade the firmware version, you can follow the instructions below.

In order for the STM32F401RE Nucleo board to be ready for programming with the mbed development environment, it is required to run the STLinkV2-1 firmware version V2.J22.M5 or later.

#Mbed programming nucleo f401re how to

This will take you to the platform page with all information on how to get started with mbed.

At the top of the mbed webpage, select the 'Platforms' button and then select ST Nucleo F401RE platform.

If you have a login and password, login to your mbed account or click the 'Signup' button to create an account.

Click the 'Login' or 'Signup' button on the home page.

Mass storage (USB Disk drive) for drag'n'drop programmingīefore plugging your Nucleo board into your PC, first complete the following steps: ¶.

Virtual Com port to send back traces to the PC.

I used Mbed OS for the programming.I want to make a custom pcb with the MCU.

Debug and programming port, to use STM32 Nucleo with standard toolchains/debuggers/programmers Hi all, im using Nucleo-144 series (STM32F767) development board in a project.

On-board ST-LINK/V2.1 interfacing with the PC, with three different communication channels via USB.

Flexible board power supply: USB VBUS or external source (3.5 V, 5 V, 7 V - 12 V).

STMicroelectronics Morpho extension pin headers for full access to all STM32F401RET6 I/Os.

Two types of extension resources, each with accessible debug pins:.

One high-performance STM32F401RET6 microcontroller with LQFP64 package and ARM Cortex-M4 CPU with FPU at 84MHz, 512 Kbytes of Flash and 96 Kbytes of RAM with a variety of peripherals.

Here is a brief summary of the highlights of this platform: An overview of this board is found here: ST Nucleo F401RE With the Nucleo board in hand, become familiar with the capabilities of the STM32F401 MCU and the pin-out of the Nucleo board.

The first step to building your connected device is to obtain an STM32F401 Nucleo board and a USB cable.

The STM32 Nucleo boards come with an integrated ST-Link debugger/programmer no need for an external probe. Sharing Arduino connectors and ST Morpho headers, STM32 Nucleo boards can easily be extended with a large number of application related hardware add-ons. The STM32F401 Nucleo board allows developers to try out new ideas and quickly create prototypes with the STM32F401 MCU. We have teamed up with ARM mbed to give you an easy to use experience to begin building your connected device. Welcome to the Era of Connected Devices! ¶ Preparing the STM32F401 Nucleo Board for Development with ARM mbed ¶